Spectra Precision ProFlex 800 Reference Manual - Manual (Page 648)

634
Query Command Library
Satellite Correcting Status:
Example $PASHQ,SGA
$PASHR,SGA,2,128,092,32,44.0,,35.0,2,4,…
See also $PASHS,NME
Automatic Output
of SGA Messages
This is a reminder on how to output SGA messages at regular
intervals of time: Use the $PASHS,NME command with the
syntax below:
$PASHS,NME,SGA,,ON,
For more details on the $PASHS,NME command, refer to the
Set Command Library Chapter.
As an example, the command below will output SGA
messages on port A at a rate of 10 seconds:
$PASHS,NME,SGA,A,ON,10
21 URA in ephemeris is not acceptable
22 SV is unhealthy according to almanac
23 Too low SNR
24 Suspected of being a ghost satellite
25
Because of too many Satellites used in the PVT, this satellite has
been deselected
26-30 Reserved for future causes of rejection
31 Other cause
Status
0 Satellite is not tracked
1 Satellite is not corrected
2 SBAS is corrected
3 DGPS is corrected
4 L1 RTK is corrected
5 L1&L2 RTK is corrected
6-14 Reserved
15 Unknown correcting status
Status Description