Spectra Precision ProFlex 800 Reference Manual - Manual (Page 284)

270
Integrating ProFlex 800 into Your Application
lower line: . The number of bars is proportional to the
strength of the signal received by the cellular antenna. You
can also use the $PASHQ,MDM to read this state.
Monitoring the
Modem
Ending the NTRIP
Connection
Direct-IP Rover (Via Modem)
Script
Action Command
Load the NTRIP source table to the
receiver: $PASHS,NTR,LOD
$PASHR,NTR,OK*14
Query the source table:
NOTE: In the receiver response, you can
find the label of the mount point you would
like the modem to connect to. If necessary,
refer to the NTRIP or RTCM standard docu-
mentation to decode this information.
$PASHQ,NTR,TBL
$PASHR,NTR,TBL
SOURCETABLE 200 OK
…
ENDSOURCETABLE
Action Command
Query the modem status and settings:
$PASHQ,MDM
$PASHR,MDM,E,9,ONLINE,...
or
$PASHQ,MDM,STS
$PASHR,MDM,STS,INIT,"Ssx
F",2G,60*77
Query the modem signal level:
$PASHQ,MDM,LVL
$PASHR,MDM,LVL,80*6E
Query the current mount point:
$PASHQ,NTR,MTP
$PASHR,NTR,MTP,NAN1*05
Action Command
Ending the NTRIP connection:
$PASHS,NTR,MTP,OFF
$PASHR,NTR,OK*14
Action Command
Set the name of the antenna connected to
the receiver: $PASHS,ANP,OWN,ASH111661
$PASHR,ACK*3D