Pwr: power status, Function, Command format – Spectra Precision ProFlex 800 Reference Manual User Manual

Page 613: Response format

599

Query Command Library

Comments

• The response to this command will be sent out once, right

after the next PPS pulse is generated.

• The response contains the GPS time at which the PPS

pulse was sent, including the offset if an offset was set
when the PPS pulse was enabled.

• Being set to a periodical output by the $PASHS,NME,PTT

command, this message is independent of the NMEA
period. It is only linked to the PPS period.

PWR: Power Status

Function

This command is used to query the power status of the
receiver.

Command Format

Syntax

$PASHQ,PWR[*cc]

Response Format

Syntax

$PASHR,PWR,PAR,f1,f2,d3,[f4],[d5],[f6],[d7],d8[,f9,f10]*cc