Spectra Precision ProFlex 800 Reference Manual - Manual (Page 313)

299
Using Serial Commands
• Wait until the USB logo appears on the receiver screen
and a message is prompted ( Upload Script?).
• Accept the request by pressing the Log button (you could
reject it by pressing the Scroll button). The receiver will
then start executing the script of commands. This is
indicated on the display screen where you can see the
number of commands to be run (on the right) and the rank
of the command being currently run (on the left). In the
example below, the receiver is running the 1st command
of the 18 ones it has to go through:
• When all the commands have been run, the receiver
comes back to the screen it was displaying before.
• Remove the USB key.
• You can now have a check on how the receiver ran each of
the commands: Connect the USB key to a computer and
edit the autoconfig.log file created on the USB key by the
receiver while executing the commands. Each correctly
executed command is followed by:
$PASHR,ACK*3D
List of Commands
All the existing commands for the receiver are here arranged
in two categories:
• Commands used to configure the receiver.
• Commands used to output the data users need in their
applications.