Spectra Precision ProFlex 800 Reference Manual - Manual (Page 395)

381
Set Command Library
$PASHS,ETH,ON*01
Relevant Query
Command
$PASHQ,ETH
See Also $PASHS,ETH,OFF
$PASHS,ETH,PAR
ETH,PAR: Ethernet Parameters
Function This command is used to set the Ethernet parameters.
Command Format Syntax
$PASHS,ETH,PAR[,DHP,s1][,ADD,s2][,MSK,s3][,GTW,s4][,DN1,s5]
[,DN2,s6][*cc]
Parameters
Example
Ethernet configuration with DHCP:
$PASHS,ETH,PAR,DHP,1*2E
Ethernet configuration without DHCP (static IP address):
$PASHS,ETH,PAR,DHP,0,ADD,10.20.2.28,MSK,255.255.255.0,GTW,
10.20.2.1,DN1,134.20.2.16,DN2,134.20.2.3*5F
Parameter Description Range Default
DHP,s1
DHCP mode:
0: Disabled (static IP
address)
1: Enabled (dynamic
IP address)
0, 1 1
ADD,s2
IP address when
s1=0
0.0.0.0-255.255.255.255 192.168.0.1
MSK,s3
Sub-network mask
when s1=0
0.0.0.0-255.255.255.255 255.255.255.0
GTW,s4
Gateway IP address
when s1=0
0.0.0.0-255.255.255.255 255.255.255.255
DN1,s5
DNS 1 IP address
when s1=0
0.0.0.0-255.255.255.255 255.255.255.255
DN2,s6
DNS 2 IP address
when s1=0
0.0.0.0-255.255.255.255 255.255.255.255
*cc Optional checksum *00-*FF