Spectra Precision ProFlex 800 Reference Manual - Manual (Page 535)

521
Query Command Library
CMR,MSI: CMR Message Status
Function This command is used in a base receiver to read the current
settings of the CMR messages the base currently generates
and outputs.
Command Format Syntax
$PASHQ,CMR,MSI[*cc]
Response Format Syntax
$PASHR,CMR,MSI,d1,d2,d3,d4,d5,d6,d7,d8,d9*cc
Parameters
Example The response line below reports four enabled CMR messages,
type “0” and “3” at 1 second, and types “1” and “2” at 30
seconds:
$PASHQ,CMR,MSI
$PASHR,CMR,MSI,4,0,1.0,1,30.0,2,30.0,3,1.0*50
See also $PASHS,CMR,TYP
$PASHQ,BAS
$PASHQ,CPD,MOD
Parameter Description Range
d1 Number of CMR messages currently output 4
d2 Message type “0” label 0
d3 Message type “0” output rate, in seconds 0-300
d4 Message type “1” label 1
d5 Message type “1” output rate, in seconds 0-300
d6 Message type “2” label 2
d7 Message type “2” output rate, in seconds 0-300
d8 Message type “3” label 3
d9 Message type “3” output rate, in seconds 0-300
*cc Checksum *00-*FF