Spectra Precision ProFlex 800 Reference Manual - Manual (Page 684)

670
Data Output
The data in this message are packed in bits rather than bytes.
So the presented types of fields are just for the sake of giving
a meaningful description of the original data packing.
NOTES:
• Most of the fields found in the DPC and DBEN data
outputs are similar.
• DPC will not be generated if the [K] option (RTK Base) is
missing.
• DPC data are affected by the last $PASHS,UTS command
run. By default, this command is set to “ON”.
• DPC data are affected by the last $PASHS,ANP,OUT
command run.
• DPC data can be made available on several ports
simultaneously.
• DPC data can be output at a rate of up to 20 Hz, but the
throughput compared to RTCM-3, CMR and ATOM may be
quite higher.
• DPC pseudo-ranges are smoothed by L1 & L2 carriers.
• L2 data are always L2P(Y) data (RINEX code W). To output
complete DPC data, the receiver must be configured
accordingly (see $PASHS,GPS).
Reminder on How
to Output DPC
Messages
Use the $PASHS,RAW command with the syntax below:
$PASHS,RAW,DPC,,ON,
For more details on the $PASHS,RAW command, refer to the
Set Command Library Chapter.
As an example, the command below will output DPC
messages on port A at a rate of 1 second:
$PASHS,RAW,DPC,A,ON,1