Spectra Precision ProFlex 800 Reference Manual - Manual (Page 511)

497
Set Command Library
Parameters
Comments
• The login and password are set to their default values after
the $PASHS,RST or $PASHS,INI command has been run.
• The httpd port is used to access the Web Server through
the network.
If for example the IP address of the receiver is 10.20.2.18
and d4=2500, you should enter the following in the
address bar of your web browser to open the Web Server:
10.20.2.18:2500
Example
Enabling the use of the Web Server with specific login and
password on httpd port 2500:
$PASHS,WEB,PAR,ON,Smith,u7lmyt,2500*69
Relevant Query
Command
$PASHQ,WEB
See Also $PASHS,WEB,PAR
WEB,USR,ADD: Adding/Modifying User Profiles
Function This command is used to add or modify user profiles. A user
profile is needed for a user to be able to access and use the
receiver status section of the Web Server.
Modifying a user profile means changing its password. This is
obtained by simply running the $PASHS,ADD,USR command
in which the existing user login is mentioned, followed by the
new password.
Parameter Description Range Default
s1
Enables (ON) or disables (OFF)
the Web Server
ON, OFF ON
s2 Administrator login 32 characters max. admin
s3 Administrator password 32 characters max. changeme
d4 httpd port 0-65535 80
*cc Optional checksum *00-*FF