Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 96)

Teledyne LeCroy Corporation Status Bar
96 USB Protocol Suite User Manual
4.6.3 Recording Activity
During recording, a segment of the Status Bar displays recording activity as a series of
vertical bars.
The more vertical bars that display, the greater the amount of activity recording. If there
are no vertical bars, there is no recording activity.
During uploading, the percent of the completed upload displays.
Note: If packets are filtered from the recording, or data are truncated, recording activity reduces.
4.6.4 Search Status
The lower right‐most segment displays the current search direction: Fwd (forward) or
Bwd (backward). Change the search direction from the Search Menu or double‐click the
Search Status segment.
4.6.5 SuperSpeed Termination Status
The lower right middle of the Status Bar shows the SuperSpeed Termination status.
Note: The status is the status of the Analyzer’s port, not of the device or host under test.
When in Analyzer‐only mode, it shows the termination status of the Analyzer A and B
ports AND the status of the far‐end Host and Device terminations (Denoted H and D).
If the analyzer is in manual termination mode, the far end values are unknown, so they are
not shown.
When in Exerciser mode, it shows the status of the Exerciser A or B port and the far end
Device or Host, using the same A, B, D, H convention.
Polling occurs when the Application CPU is not busy.
The polling interval is reflected in a small dot (.) at the end of the string in the Status Bar.
Note: Terminations reflect what the Analyzer is presenting to the device or host. The Analyzer changes
these terminations while attempting to connect the Host DUT and Device DUT together using
the SuperSpeed connection protocol. For more information about the Recording buttons, see
“Recording” on page 86 .