Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 44)

Teledyne LeCroy Corporation Advisor T3
44 USB Protocol Suite User Manual
2.2.3 Rear Panel
Figure 2.3: Advisor T3 Rear Panel
The rear panel has the following indicators and connectors:
USB Type B connector for connection to host machine
Sync/Data Micro DB‐25 (25‐pin) external interface connector
(cable sold separately)
Trigger In SMA external trigger input. Note: Edge detected. (Rising
edge only) Voltage required: Signal needs to be >
800mV to see a logic "1", Signal needs to be < 400mV to
see a logic "0" . Maximum value of the external input
signal which can be input is 5 V. Minimum value is 0 V.
Trigger Out SMA external trigger output.
Pulse Width = 280 ns. Pulse Voltage = 3.3 Volts into 1
MegOhms. Pulse Voltage = 2.7 Volts into 50 Ohms.
Pulse is positive going.
Power Connector 12V, 3A DC
Power Switch (0/1)
WARNING: Do not open the enclosure. No operator serviceable parts are inside. Refer
servicing to Teledyne LeCroy customer care.