Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 198)

Teledyne LeCroy Corporation Class/Vendor Decoding Options
198 USB Protocol Suite User Manual
 RNDIS Interrupt Notification ‐ Microsoft
 Still Image/PTP/MTP/PictBridge Interrupt
 Video Interrupt
 WA Radio Notif Endp
The Class/Vendor Endpoint Decoding options an IN endpoint are:
 No Decoding
 ATAPI MMC4 In Endp
 ATAPI SPC3 In Endp
 ATAPI SSC2 In Endp
 CCID Bulk In Message
 CDC Data Bulk In w/ Cmd Wrapper
 CDC Data Bulk In w/ Prot & Cmd Wrapper
 CDC Data Bulk In w/ Prot Wrapper
 Communication Class CDC EEM Bulk In
 Display DATA
 HCI data in
 HCI SCO in
 HTTP In Endp
 ICCD Bulk In Message
 IP_ET0800 (Internet Protocol) In Endp
 IPv6_ET086DD (Internet Protocol) In Endp
 IrDA Bridge in Endp
 Mass Strg Bulk‐Only SCSI In Endp
 Mass Strg UASP Data In Endp
 Mass Strg UASP Status Endp
 Mass Strg UFI_CBI Bulk In Endp
 MBIM Bulk In
 NCM Bulk In
 PHDC Bulk In Message
 RNDIS Bulk IN
 Still Image/PTP/MTP/PictBridge Bulk In
 TCP (Transmission Control Protocol) In Endp
 USB3 Vision Events
 USBTMC Bulk IN Endp
 Video Bulk In
 Virtual UART
9. Select the type of decoding.
OR
Select No Decoding if you do not want any specific decoding.
10. The USB Protocol Suite decoding engine uses different rules like “Short Packet”
[Packets with length less than Max packet size], “Transferring required data by
endpoint” to collect transactions under transfers. But, in some cases [like interrupt
transfers] transfer collection uses a simple rule of “1 transaction 1 transfer”. When
this option is set as “yes”, any transaction at selected endpoint will make a transfer
level packet which could be decoded by transfer level scripts. To select this model of
transfer, use the "1 Tran 1 Xfer" column to select it (see
Figure 8.6 on page 197 ).