Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 86)

Teledyne LeCroy Corporation Tool Bar
86 USB Protocol Suite User Manual
4.3.5 Recording
4.3.6 Generator (Traffic Generation for USB 3)
Please see “Traffic Generation 3.0 Exerciser” on page 349 .
Superspeed (USB 3.0) receiver terminations of Analyzer:
M3i: If both Analyzer ports are set to Auto in Recording
Options, this button is dimmed. If either port is set to Manual, this
button can apply or remove USB 3.0 termination.
M3: This button is always enabled, and Auto mode is not
supported.
Start
Recording
Manual Trigger
Stop
Recording Repeat Upload


Momentary VBus Disconnect (On systems that support it)
Causes the VBus power between the Host and the Device
connected through the Analyzer A and B USB ports to be broken
for 1 second, simulating a unplug‐plugin cycle. This is the
recommended method of creating plug‐in scenarios.
Note: This button can be changed to make it work as a toggle
between VBus On and VBus off. This can be modified on
the Recording Options General tab.
Note: When Disconnect is done during recording, it may cause
capturing of IPS (undecodable symbols) and false triggering
of CRC triggers, because packets will be abruptly stopped in
the middle of a symbol stream.
Note: Disconnection of USB or Ethernet during capture or
uploading of trace data is not supported, and may cause
the software to malfunction or crash.
Go to USB 3.0 Exerciser
window.
Manual Trigger
Display Export to Script dialog.
Repeat Upload