Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 238)

Teledyne LeCroy Corporation Using the Navigator
238 USB Protocol Suite User Manual
To set the highest packet viewable, drag the bottom delimiter down. Stop when the tool
tip indicates you are at the desired highest packet.
Figure 9.26: Navigator Delimiter
To Determine Current Position
In addition to the two yellow range delimiters, the slider has a golden current‐position
indicator (see above). The current‐position indicator shows where you are in the trace
display with respect to the possible viewing range.
For example, suppose you set viewing range to packet 0 through packet 500 (the top
range delimiter is at packet 0, and the bottom range delimiter is at packet 500). If you
then move the current‐position indicator on the slider to midway between the top and
bottom delimiters, then packet 250 appears in the middle of the trace display.
To Reset Navigator Range
You can reset the Navigator range using the toolbar Navigator Range button. Press the
button to bring up the Navigator Range drop‐down menu.
The menu has the following options:
 Set Range to Whole Trace: Allows you to reset the range to include the entire
trace file contents. The top range delimiter is placed at the lowest packet num‐
ber in the trace. The bottom range delimiter is placed at the highest packet num‐
ber in the trace.
Bottom Delimiter
Top Delimiter
Current Position Indicator