Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 55)

USB Protocol Suite User Manual 55
Chapter 3
Installation
The Analyzer software installs on a Microsoft
®
Windows
®
XP, Windows 8 or Windows 7 (32
or 64) host machine.
Important: Please uninstall any versions of USBTracer, USB Advisor, or USBMobile HS
software on your host machine BEFORE installing USB Protocol Suite. The older software
is not compatible with the new software and device drivers. You can load files recorded
using the old software into USB Protocol Suite, which will automatically convert them to
the new format.
3.1 Installing the Analyzer Software on the Host Machine
Note:
You must install the software before connecting the Analyzer to the host machine for the first
time.
Install the software on the host machine administering the Analyzer:
1. Insert the Installation CD into the CD drive of the host machine that administers the
Analyzer.
2. Follow the on‐screen installation instructions to install the application on the host
machine’s hard disk.
3. It is recommended that you restart your host machine after installation.
Note: The installer adds a service which helps keep your software up‐to‐date. If you receive a message
from your anti‐virus software, please do one of the following: Disable your antivirus software
until the USB Protocol Suite has completed installing, or choose not to use the Automatic Update
feature when you are presented with this option during the installation.
3.2 Setting Up the Analyzer - USB Connection
To set up an Analyzer using a USB connection:
1. Connect the AC power cord to the rear of the Analyzer and to a 100‐volt to 240‐volt,
50‐Hz to 60‐Hz, 100‐W power outlet.
Note: The Analyzer is capable of supporting supply voltages between 100 volts and 240 volts, 50 Hz or
60 Hz, thus supporting all supply voltages around the world.