4 dragging a button to the main display area – Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) User Manual
Page 302
Teledyne LeCroy Corporation
Recording Rules ‐ USB 3.0 (Voyager/Advisor T3 only)
302
USB Protocol Suite User Manual
10.8.4
Dragging a Button to the Main Display Area
After you create an Event button in the Available Events area, you can drag the button to
the Main Display area and drop it in the appropriate cell (a cell is a grayed‐out rectangle
with a dashed line around it). You can think of each cell as a target for drag‐and‐drop of
an Event button (see
There are two types of cell that might appear: Sequence cell and State cell. In the
Main Display area, they are labelled as follows:
Sequence cell: Drag an event here to add a new sequence.
State cell: Drag an event here to add another state. Note: Recording Rules for
USB 3.0 currently do not support more than two independent states.
Figure 10.28: Sequence and State Cells
If there currently are no events in the Main Display area, a single sequence cell appears at
the top of the area.
To drag‐and‐drop the Event button, see