Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 22)

Teledyne LeCroy Corporation Voyager M3/M3i Analyzer
22 USB Protocol Suite User Manual
The trace viewer application displays recorded data in colored graphics. The application
has advanced search and viewing capabilities that allow you to quickly locate specific
data, errors, and other conditions.
The system functions with any personal host machine having the Microsoft
®
Windows
®
XP, Windows 8, or Windows 7 (32 or 64) operating system and a functional
USB interface or Ethernet port.
The system provides on‐the‐fly detection of, and triggering on, such events as Tokens and
Errors. Whether recording manually or with a specified trigger condition, the system
continuously records the link data, in a wrap‐around fashion, until manually stopped or
until the system detects the Trigger Event and records the specified post‐trigger amount
of link data.
Upon detection of a triggering event, the Analyzer continues to record data up to a point
specified by you. You can individually enable or disable real‐time event detection to allow
triggering on events as they happen, including predefined exception or error conditions
and user‐defined sets of trigger events. An externally supplied signal can trigger the
Analyzer.
You can use search functions to investigate particular events. In addition to immediate
analysis, you can print any part of the data. You can save the data on disk for later
viewing. You can generate timing information and data analysis reports.
Please refer to the Universal Serial Bus Specification for details on the protocol. The USB
specification is available from the USB Implementers Forum (USB‐IF) at:
1.2.3 Features
General
 Fully complies with USB specification revisions.
 Supports the Link Power Management extension.
 Uses field‐upgradeable firmware and recording engine.
 Supports all USB speeds (5 Gb/s, 480 Mb/s, 12 Mb/s, and 1.5 Mb/s).
 Displays bus traffic using color and graphics in the user‐friendly CATC Trace inter‐
face.
 Has free non‐recording, view‐only Trace Viewer software.
 Comes with online manual.
 Self‐diagnoses at power on.
 Uses software upgradable Exerciser function.
 Allows remote control of USB analyzers in a network.
USB Implementers Forum
1730 SW Skyline Blvd. 
Suite 203
Portland, OR 97221 Tel: +1/503.296.9892
Fax: +1/503.297.1090
Web: http://www.usb.org/