Teledyne LeCroy USB Protocol Suite User Manual (Voyager_Advisor T3_Mercury) - Manual (Page 196)

Teledyne LeCroy Corporation Class/Vendor Decoding Options
196 USB Protocol Suite User Manual
 CCID Bulk Out Message
 CDC Data Bulk Out w/ Cmd Wrapper
 CDC Data Bulk Out w/ Prot & Cmd Wrapper
 CDC Data Bulk Out w/ Prot Wrapper
 Communication Class CDC EEM Bulk Ou
 Display DATA
 HCI data out
 HCI SCO out
 HID Interrupt out Endp
 HTTP Out Endp
 ICCD Bulk Out Message
 IP_ET0800 (Internet Protocol) Out Endp
 IPv6_ET0800 (Internet Protocol) Out Endp
 IrDA Bridge Out Endp
 Mass Strg Bulk‐Only SCSI Out Endp
 Mass Strg UASP Command Endp
 Mass Strg UASP Data Out Endp
 Mass Strg UFI_CBI Bulk Out Endp
 MBIM Bulk Out
 NCM Bulk Out
 PHDC Bulk Out Message
 RNDIS_PACKET_MSG Bulk Out
 Still Image/PTP/MTP/PictBridge Bulk Out
 TCP (Transmission Control Protocol) Out Endp
 USBTMC Bulk Out Endp
 Video Bulk Out
 Virtual UART
The Cmd Set options for an OUT endpoint for Bulk Transfer Type are:
 SPC‐4
 SBC‐3
 SMC‐3
 SSC‐4
 MMC‐6
 SSC‐2
 SES‐2
 SAT‐3
Note: The Cmd Set options are only available for the Mass Strg Bulk‐Only SCSI Out Endp selection in
Class/Vendor Endpoint Decoding.