Accton Technology ES4710BD - Manual (Page 97)

96
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Parameters: is the host name, up to 15 characters are allowed; is the
corresponding IP address for the host name and takes a decimal format.
Command mode: Global Mode
Usage Guide: Sets the association between host and IP address, which can be used in commands
like “ping ”.
Example: Setting the IP address of a host with the hostname of “ES4710BD” to 200.121.1.1.
Switch(Config)#ip host ES4710BD 200.121.1.1
Related commands: telnet, ping, traceroute
5.1.9 hostname
Command: hostname
Function: Sets the prompt in the switch command line interface.
Parameter is the string for the prompt, up to 30 characters are allowed.
Command mode: Global Mode
Default: The default prompt is ES4710BD.
Usage Guide: With this command, the user can set the command line prompt of the switch
according to their own requirements.
Example: Setting the prompt to “Test”.
Switch(Config)#hostname Test
Test(Config)#
5.1.10 reload
Command: reload
Function: Warm resets the switch.
Command mode: Admin Mode
Usage Guide: The user can use this command to restart the switch without power off .
5.1.11 set default
Command: set default
Function: Resets the switch to factory settings.
Command mode: Admin Mode
Usage Guide: Resets the switch to factory settings. That is to say, all configurations made by the
user to the switch will disappear. When the switch is restarted, the prompt will be the same as when
the switch was powered on for the first time.
Note: After use of this command, “write” command must be executed in order to save the operation.
The switch will reset to factory settings after restart.
Example:
Switch#set default
Are you sure? [Y/N] = y
Switch#write