Accton Technology ES4710BD - Manual (Page 519)

518
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Parameters: is the interval for re-authentication, in seconds, the valid range is 1 to
65535.
Command mode: Global Mode
Default: The default value is 3600 seconds.
Usage Guide: dot1x re-authentication must be enabled first before supplicant re-authentication
interval can be modified. If authentication is not enabled for the switch, the supplicant
re-authentication interval set will not take effect.
Example: Setting the re-authentication time to 1200 seconds.
Switch(Config)#dot1x timeout re-authperiod 1200
20.2.2.16 dot1x timeout tx-period
Command: dot1x timeout tx-period <seconds>
no dot1x timeout tx-period
Function: Sets the interval for the supplicant to re-transmit EAP request/identity frame; the “no
dot1x timeout tx-period” command restores the default setting.
Parameters: is the interval for re-transmission of EAP request frames, in seconds; the
valid range is 1 to 65535.
Command mode: Global Mode
Default: The default value is 30 seconds.
Usage Guide: Default value is recommended.
Example: Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(Config)#dot1x timeout tx-period 1200
20.2.2.17 radius-server accounting host
Command: radius-server accounting host <ip-address> [port <port-number>] [primary]
no radius-server accounting host <ip-address>
Function: Specifies the IP address and listening port number for RADIUS accounting server; the
“no radius-server authentication host ” command deletes the RADIUS
accounting server
Parameters: <ip-address> stands for the server IP address; <port-number> for server listening port
number from 0 to 65535; primary for primary server. Multiple RADIUS sever can be
configured and would be available. RADIUS server will be searched by the configured
order if primary is not configured, otherwise, the specified RADIUS server will be
used first.
Command mode: Global Mode
Default: No RADIUS accounting server is configured by default.
Usage Guide: This command is used to specify the IP address and port number of the specified
RADIUS server for switch accounting, multiple command instances can be
configured. The <port-number> parameter is used to specify accounting port number,
which must be the same as the specified accounting port in the RADIUS server; the
default port number is 1813. If this port number is set to 0, accounting port number
will be generated at random and can result in invalid configuration. This command
can be used repeatedly to configure multiple RADIUS servers communicating with
the switch, the switch will send accounting packets to all the configured accounting