Accton Technology ES4710BD - Manual (Page 388)

387
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
(1) Configure RIP sending mechanism
a. Configure regular RIP packets transmission
b. Configure RIP advertisement
Command Explanation
RIP configuration mode
[no] rip broadcast
Indicates RIP layer 3 switch allows all ports to
send broadcast/multicast packets; the “no rip
broadcast” command disables all ports to send
broadcast/multicast packets
2) Configure RIP routing parameters.
a. Configure route aggregation
Command Explanation
RIP configuration mode
auto-summary
no auto-summary
Configures route aggregation; the “no
auto-summary” command disables route
aggregation.
b. configure route introduction (default route metric, configure routes of the other protocols to be
introduced in RIP)
Command Explanation
RIP configuration mode
default-metric <value>
no default-metric
Sets the default route metric for route to be
introduced; the “no default-metric” command
restores the default setting.
redistribute { static | ospf | bgp} [ metric
<value> ]
no redistribute { static | ospf | bgp }
Introduces static, OSPF or BGP routes to RIP
packets; the “no redistribute { static | ospf |
bgp }” command cancels the introduced routes of
specified protocol.
c. Enable interface to send/receive additional routing metric of RIP packets
Command Explanation
Interface Mode
ip rip metricout <value>
no ip rip metricout
Sets the additional route metric for route on
sending RIP packets from the interface; the “no ip
rip metricout” command restores the default
setting.
ip rip metricin <value>
no ip rip metricin
Sets the additional route metric for route on
receiving RIP packets from the interface; the “no
ip rip metricin” command restores the default
setting.
d. Configure interface authentication mode and password
Command Explanation
Interface Mode