Accton Technology ES4710BD - Manual (Page 383)

382
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Destination Mask Nexthop Interface Pref
C 2.2.2.0 255.255.255.0 0.0.0.0 vlan2 0
C 4.4.4.0 255.255.255.0 0.0.0.0 vlan4 0
S 6.6.6.0 255.255.255.0 9.9.9.9 vlan9 1
R 7.7.7.0 255.255.255.0 8.8.8.8 vlan8 120
Displayed information Explanation
C - connected Direct route, the segment directly connects to
the layer 3 switch.
S - static Static route, route are manually configured by
the user
R - RIP derived RIP route, route are obtained through RIP
protocol in layer 3 switch
O - OSPF derived OSPF route, route obtained through OSPF
protocol in layer 3 switch
A - OSPF ASE Route introduced by OSPF
B - BGP derived BGP route, the route obtained through BGP
protocol.
Destination destination network
Mask Mask of the destination network
Nexthop Next hop IP address
Interface The layer 3 switch interface to next hop.
Pref Route priority, if another route types exists to
the destination network, only the route of the
higher priority will be displayed in the core
route table.
18.2.4 Configuration Scenario
The figure below is a simple network consisting of three ES4710BD layer 3 switches, the network
mask for all switches and PC IP addresses is 255.255.255.0. PC1 and PC3 are connected via the
static route set in Swtich1 and Switch3; PC3 and PC2 are connected via the static route set in Switch
3 to Switch 2; PC 1 and PC3 is connected via the default route set in Switch2.