Accton Technology ES4710BD - Manual (Page 403)

402
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
SwitchC#config
SwitchC(Config)# interface vlan 2
SwitchC(Config-If-vlan2)# ip address 20.1.1.2 255.255.255.0
SwitchC (c config-If-vlan2)#exit
！
Enable RIP
SwitchC(Config)#router rip
SwitchC(Config-router-rip)#exit
！
Enable vlan2 to send/receive RIP packets
SwitchC(Config)#interface vlan 2
SwitchC (Config-If-vlan2)#ip rip work
SwitchC (Config-If-vlan2)exit
SwitchC(Config)#exit
SwitchC#
18.3.4 RIP Troubleshooting Help
1. Monitor and Debug Commands
2. RIP Troubleshooting Help
18.3.4.1 Monitor and Debug Commands
Command Explanation
Admin Mode
show ip rip
Displays the current running status and
configuration information for RIP. The user can
decide whether the configurations are correct or
not and perform RIP troubleshooting according to
the output of this command.
show ip route
Displays route table information, RIP routing
information can be checked.
show ip protocols Displays protocol information
[no] debug ip rip packet Displays all RIP packets received and sent.
[no] debug ip rip recv Displays all RIP packets received
[no] debug ip rip send Displays all RIP packets sent.
（ 1）show ip rip
Displayed information:
RIP information:
Automatic network summarization is not in effect.
default metric for redistribute is :16
neigbour is :NULL
preference is :100
Explanation to displayed information:
Displayed information Explanation