Accton Technology ES4710BD - Manual (Page 537)

536
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
(1) Configure the preemptive mode for VRRP
Command Explanation
VRRP protocol configuration mode
preempt-mode {true| false} Configures the preemptive mode for VRRP
(2) Configure VRRP priority
Command Explanation
VRRP protocol configuration mode
priority < priority > Configures VRRP priority
(3) Configure VRRP Timer intervals
Command Explanation
VRRP protocol configuration mode
advertisement-interval Configures VRRP timer value (in seconds)
(4) Configure VRRP interface monitor
Command Explanation
VRRP protocol configuration mode
circuit-failover {IFNAME | Vlan <ID>}
no circuit-failover
Configures VRRP interface monitor, the "no
circuit-failover" removes monitor to the
interface
21.1.2 VRRP Configuration Commands
21.1.2.1 router vrrp
Commands: router vrrp <vrid>
no router vrrp <vrid>
Function: Creates/Removes the Virtual Router
Parameters: < vrid > is the Virtual Router number ranging from 1 to 255.
Default: Not configured by default.
Command mode: Global Mode
Usage Guide: This command is used to create/remove Virtual Router, which is identified by a
unique Virtual Router number. Virtual Router configurations are only available when a Virtual
Router is created.
Example: Configuring a Virtual Router with number 10
Switch(config)# router vrrp 10
21.1.2.2 virtual-ip