Accton Technology ES4710BD - Manual (Page 521)

520
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
20.2.2.20 radius-server key
Command: radius-server key
no radius-server key
Function: Specifies the key for the RADIUS server (authentication and accounting); the “no
radius-server key” command deletes the key for RADIUS server.
Parameters: is a key string for RADIUS server, up to 16 characters are allowed.
Command mode: Global Mode
Usage Guide: The key is used in the encrypted communication between the switch and the
specified RADIUS server. The key set must be the same as the RADIUS server set,
otherwise, proper RADIUS authentication and accounting will not perform properly.
Example: Setting the RADIUS authentication key to be “test”.
Switch(Config)# radius-server key test
20.2.2.21 radius-server retransmit
Command: radius-server retransmit
no radius-server retransmit
Function: Configures the re-transmission times for RADIUS authentication packets; the “no
radius-server retransmit” command restores the default setting
Parameters: is a retransmission times for RADIUS server, the valid range is 0 to 100.
Command mode: Global Mode
Default: The default value is 3 times.
Usage Guide: This command specifies the retransmission time for a packet without a RADIUS
server response after the switch sends the packet to the RADIUS server. If
authentication information is missing from the authentication server, AAA
authentication request will need to be re-transmitted to the authentication server. If
AAA request retransmission count reaches the retransmission time threshold without
the server responding, the server will be considered to as not working, the switch
sets the server as invalid.
Example: Setting the RADIUS authentication packet retransmission time to five times.
Switch(Config)# radius-server retransmit 5
20.2.2.22 radius-server timeout
Command: radius-server timeout
no radius-server timeout
Function: Configures the timeout timer for RADIUS server; the “no radius-server timeout”
command restores the default setting.
Parameters: is the timer value (second) for RADIUS server timeout, the valid range is 1
to 1000.
Command mode: Global Mode
Default: The default value is 3 seconds.
Usage Guide: This command specifies the interval for the switch to wait RADIUS server response.
The switch waits for corresponding response packets after sending RADIUS Server
request packets. If RADIUS server response is not received in the specified waiting