Accton Technology ES4710BD User Manual
Page 439
438
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
A 5.1.2.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.3.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.4.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.5.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.6.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.7.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.8.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.9.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.10.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.11.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.12.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.13.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.14.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.15.0 255.255.255.0 12.1.1.2 Vlan12 150
A 5.1.16.0 255.255.255.0 12.1.1.2 Vlan12 150
O 5.1.17.0 255.255.255.0 12.1.1.2 Vlan12 110
---More---
Where, O stands for OSPF route, i.e., the OSPF route with the destination network address of
5.1.17.0, network mask of 255.255.255.0, the next hop address of 12.1.1.2 and the forwarding
interface of Ethernet vlan12. The priority value of this route is 110.
（
3）show ip ospf ase
The “show ip ospf ase” command can be used to display information about OSPF autonomous
system exterior routes.
For example, displayed information can be:
Switch#show ip ospf ase
Destination AdvRouter NextHop Age SeqNumber Type Cost
10.1.1.125 11.11.1.2 11.1.1.2 3 300 2 20
Displayed information
Explanation
Destination
Target network segment or address
AdvRouter Route
election
NextHop Next
hop
address
Age Aging
time
SeqNumber Sequence
number
Type
Exterior routes type for introduction
Cost
Cost for introducing exterior routes
（
4）show ip ospf cumulative
The “show ip ospf cumulative” command can be used to display statistics about the OSPF protocol.
For example, displayed information can be:
Switch#show ip ospf cumulative
IO cumulative