Accton Technology ES4710BD User Manual
Page 393
392
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
18.3.2.2.6 ip rip metricout
Command: ip rip metricout <value>
no ip rip metricout
Function: Sets the additional route weight sending RIP packets on the interface; the “no ip rip
metricout” command restores the default setting.
Parameters: < value> is the additional route metric, ranging from 0 to 15.
Default: The default additional route metric used for RIP to send packets is 0.
Command mode: Interface Mode
Example: Setting vlan1 interface on the additional route metric of receiving RIP packets to 5, and
sending RIP packets to 3.
Switch(Config-If-Vlan1)#ip rip metricin 5
Switch(Config-If-Vlan1)#ip rip metricout 3
Related command: ip rip metricin
18.3.2.2.7 ip rip input
Command: ip rip input
no ip rip input
Function: Enables receiving RIP packets on the interface; the “no ip rip input” command disables
receiving RIP packets on the interface
Default: Receiving RIP packet is enabled by default.
Command mode: Interface Mode
Usage Guide: This command is used with the other two commands “ip rip output” and “ip rip
work”, “ip rip work” is equal to “ip rip input” & “ip rip output” in function, the latter two
commands control the receiving and sending of RIP packet on the interface, the former equals the
total of the latter two commands.
Related command: ip rip output
18.3.2.2.8 ip rip output
Command: ip rip output
no ip rip output
Function: Enables sending RIP packets on the interface; the “no ip rip output” command disables
sending RIP packets on the interface
Default: Sending RIP packet is enabled by default.
Command mode: Interface Mode
Usage Guide: This command is used with two other commands: “ip rip output” and “ip rip work”.
“ip rip work” is equal to “ip rip input” & “ip rip output” in function, the latter two commands
control the receiving and sending of RIP packet on the interface, the former equals the total of the
latter two commands.
Related command: ip rip input
18.3.2.2.9 ip rip receive version