Accton Technology ES4710BD - Manual (Page 490)

489
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Command mode: Admin Mode
Usage Guide: This command is used to display DVMRP route table entries; DVMRP maintains
separated unicast route tables for RPF check.
Example: Displaying DVMRP routing information.
Switch #show ip dvmrp route
Switch #
Destination/Mask Nexthop Interface Gateway Metric state
192.168.1.0/24 192.168.1.11 Vlan1 No-Gateway 1 active
Switch #
Displayed information Explanation
Destination/Mask Target network segment or address and mask
Nexthop Next hop address
Interface The interface on which the route is discovered
Gateway Gateway address
Metric Route metric value
state Route state (active, hold, etc)
19.5.4.1.4 show ip dvmrp tunnel
Command: show ip dvmrp tunnel [<ifname>]
Function: Displays information for a DVMRP tunnel.
Parameters: is the interface name, i.e., display the tunnel information of the specified
interface.
Default: Not displayed.
Command mode: Admin Mode
Example: Displaying tunneling configuration information of Ethernet interface vlan1.
Switch #show ip dvmrp tunnel vlan1
Name: dvmrp2, Index: 7, State:1195, Parent: 3, Localaddr: 192.168.1.11, Remote:
1.1.1.1
Switch #
Displayed information
Explanation
Name Tunnel interface name (auto-generated by the
system)
Index Tunnel interface index number
State Tunnel interface status
Parent The index number of the parent interface for
the tunnel interface
Localaddr Local address of the tunnel interface
Remote Remote end address of the tunnel