Accton Technology ES4710BD - Manual (Page 207)

206
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Switch(Config-ethernet1/8)#switchport mode access
Switch(Config-ethernet1/8)#switchport access vlan 100
Switch(Config-ethernet1/8)#exit
9.2.2.4 switchport interface
Command: switchport interface <interface-list>
no switchport interface <interface-list>
Function: Assigns Ethernet ports to VLAN; the “no switchport interface <interface-list>”
command deletes one or one set of ports from the specified VLAN.
Parameters: <interface-list> is the port list to be added or deleted, “;” and “-“ are supported, for
example: ethernet 1/1;2;5 or ethernet 1/1-6;8.
Command mode: VLAN Mode
Default: A newly created VLAN contains no ports by default.
Usage Guide: Access ports are normal ports and can join a VLAN, but a port can only join one
VLAN for at a time.
Example: Assigning Ethernet ports 1, 3, 4-7, 8 of slot 1 to VLAN100.
Switch(Config-Vlan100)#switchport interface ethernet 1/1;3;4-7;8
9.2.2.5 switchport mode
Command: switchport mode {trunk|access}
Function: Sets the port in access mode or trunk mode.
Parameters: trunk means the port allows traffic of multiple VLANs; access indicates the port
belongs to one VLAN only.
Command mode: Interface Mode
Default: The port is in Access mode by default.
Usage Guide: Ports in trunk mode are called Trunk ports. Trunk ports can allow traffic of multiple
VLANs to pass through, VLANs in different switches can be interconnected with the Trunk port
interconnections. Ports under access mode are called Access ports. An access port can be assigned to
one and only one VLAN at a time.
Example: Setting port 1/5 to trunk mode and port 1/8 to access mode.
Switch(Config)#interface ethernet 1/5
Switch(Config-ethernet1/5)#switchport mode trunk
Switch(Config-ethernet1/5)#exit
Switch(Config)#interface ethernet 1/8
Switch(Config-ethernet1/8)#switchport mode access
Switch(Config-ethernet1/8)#exit
9.2.2.6 switchport trunk allowed vlan