Accton Technology ES4710BD - Manual (Page 318)

317
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
14.5.2 DHCP Troubleshooting Help
If the DHCP clients cannot obtain IP addresses and other network parameters, the following
procedures can be followed after DHCP client hardware and cables have been verified to be ok.
&
Verify the DHCP server is running, start the related DHCP server if not running.
& If the DHCP clients and servers are not in the same physical network, verify that the router
responsible for DHCP packet forwarding has DHCP relay function. If DHCP relay is not
available for the intermediate router, it is recommended to replace the router or upgrade its
software to one that has a DHCP relay function.
& In such case, the DHCP server should be examined for an address pool that is in the same
segment of the switch VLAN, such a pool should be added if not present. (This does not
indicate ES4710BD cannot assign IP address for different segments, see solution 2 for details.)
& If in DHCP service, pools for dynamic IP allocation and manual binding are conflicting, i.e., if
command “network-address” and “host” are run for a pool, then only one of them will take
effect; furthermore, in manual binding, only one IP-MAC binding can be configured in a pool.
If multiple bindings are required, multiple manual pools can be created and IP-MAC bindings
set for each pool. New configuration in the same pool will overwrite the previous
configuration.
14.6 Web management
14.6.1 DHCP server configuration
Click “DHCP configuration”, to open switch DHCP function configuration management list. User
may make switch DHCP function configurations
14.6.2 Enable DHCP
Click “DHCP configuration”, “DHCP server configuration”, Enable DHCP. You may configure
enable or disable the DHCP server, configure address collision log server function, and more
z
DHCP server status - enables, disables the DHCP server function. This is the same as CLI
command 14.2.2.19)
z Conflict logging status - enables, disables the DHCP server checking address conflict log
function. This is the same as CLI command 14.2.2.9
z Logging server(optional) – assign a DHCP logging server IP address. This is the same as CLI
command 14.2.2.12
z Logging server port (optional,1-65535) – assign a DHCP logging server port ID
Example: Choose DHCP server status as open, choose Conflict logging status as open, configure
Logging server as 10.0.0.1, configure Logging server port as 45, click Apply button, to apply the
configuration to switch..