Accton Technology ES4710BD User Manual
Page 382
381
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
[
Parameters:
route priority, ranging from 1 to 255, the smaller preference indicates higher priority.
Default: The default priority for static route of ES4710BD is 1.
Command mode: Global Mode
Usage Guide: When configuring the next hop for static route, next hop IP address can be specified
for routing packets.
The default preference of all route type in ES4710BD is listed below:
Route Type
Preference Value
Direct route
0
Static Route
1
OSPF 110
RIP 120
IBEP 200
EBGP 20
By default, a direct route has the highest priority, and static route, EBGP, OSPF, RIP and IBGP have
descending priorities in the order listed.
Example:
Example 1: adding a static route
Switch(Config)#ip route 1.1.1.0 255.255.255.0 2.1.1.1
Example 2: adding a default route
Switch(Config)#ip route 0.0.0.0 0.0.0.0 2.2.2.1
18.2.3.2.2 show ip route
Command: show ip route [dest <destination>] [mask <destMask>] [nextHop <nextHopValue>]
[protocol {connected | static | rip| ospf | ospf_ase | bgp | dvmrp}] [<vlan-id>]
[preference <pref>] [count]
Function: Displays the route table.
Parameters: <destination> is the destination network address; <destMask> is the mask for
destination network; <nextHopValue> stands for the IP address of next hop; connected
for direct route; static for static route; rip for RIP route; ospf for OSPF route; ospf_ase
for route introduced by OSPF; ospf_asebgp for BGP route; bgpdvmrp for DVMRP
route; <vlan-id> for VLAN identifier; <pref> for router priority, ranging from 0 to 255;
count displays the number of IP route table entries.
Command mode: Admin Mode
Usage Guide: Displays the content of core route table including: route type, destination network,
mask, next hop address, interface, etc.
Example:
Switch#show ip route
Codes: C - connected, S - static, R - RIP derived, O - OSPF derived
A - OSPF ASE, B - BGP derived