Accton Technology ES4710BD - Manual (Page 169)

168
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
2. Configure the properties for the network management port
Command Explanation
Network Management Port Configuration
shutdown
no shutdown
Enables/Disables network management port
speed {auto| force10| force100| } Sets network management port speed
duplex {auto| full| half} Sets network management port duplex mode
loopback
no loopback
Enables/Disables loopback test function for
network management port
ip address
no ip address [ ]
Configures or cancels the IP address for
network management port.
7.2.3.2 Network Management Port Configuration Commands
7.2.3.2.1 duplex
Command: duplex {auto| full| half }
Function: Sets network management port duplex mode
Parameters: auto for auto-negotiation full-duplex mode; full for forced full-duplex mode; half
for forced half-duplex mode.
Command mode: Network management port configuration Mode
Default: The default duplex mode is set to auto-negotiation.
Usage Guide: According to IEEE 802.3, the auto-negotiation for port speed and duplex are linked.
If the duplex setting of the port is auto-negotiation, the port speed will be set to auto-negotiation
automatically; if the port duplex mode changes from auto-negotiation to forced full/half-duplex, the
port speed will also become forced mode, the forced speed will be the port speed before this
command.
It is strongly recommended for the users to set all port speed and duplex mode to auto-negotiation,
this can minimize protocol-related connection problems. If forced speed/duplex mode needs to be
set, the speed/duplex mode setting of both ends must be verified to be the same.
Example: Setting the network management port to forced full-duplex mode.
Switch(Config)#interface ethernet 0
Switch(Config-Ethernet0)#duplex full
Command Explanation
Global Mode
interface ethernet
Enters the network management
port configuration mode