Accton Technology ES4710BD - Manual (Page 306)

305
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Command: lease { [] [][] | infinite }
no lease
Function: Sets the lease time for addresses in the address pool; the “no lease” command restores
the default setting.
Parameters: is number of days from 0 to 365; is number of hours from 0 to 23;
is number of minutes from 0 to 59; infinite means perpetual use.
Default: The default lease duration is 1 day.
Command Mode: DHCP Address Pool Mode
Usage Guide: DHCP is the protocol to assign network addresses dynamically instead of
permanently, hence the introduction of ease duration. Lease settings should be
decided based on network conditions: too long lease duration offsets the flexibility
of DHCP, while too short duration results in increased network traffic and
overhead. The default lease duration of ES4710BD is 1 day.
Example: Setting the lease of DHCP pool “1” to 3 days 12 hours and 30 minutes.
Switch(dhcp-1-config)#lease 3 12 30
14.2.2.14 netbios-name-server
Command: netbios-name-server [[…]]
no netbios-name-server
Function: Configures WINS servers’ address; the “no netbios-name-server” command deletes the
WINS server.
Parameters: address1…address8 are IP addresses, in decimal format.
Default: No WINS server is configured by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: This command is used to specify WINS server for the client, up to 8 WINS server
addresses can be configured. The WINS server address assigned first has the highest
priority. Therefore, address 1 has the highest priority, and address 2 the second, and
so on.
14.2.2.15 netbios-node-type
Command: netbios-node-type ｛b-node|h-node|m-node|p-node|｝
no netbios-node-type
Function: Sets the node type for the specified port; the “no netbios-node-type” command cancels
the setting.
Parameters: b-node stands for broadcasting node, h-node for hybrid node that broadcasts after
point-to-point communication; m-node for hybrid node to communicate in point-to-point after
broadcast; p-node for point-to-point node; is the node type in Hex from 0 to FF.
Default: No client node type is specified by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: If client node type is to be specified, it is recommended to set the client node type to