Accton Technology ES4710BD - Manual (Page 100)

99
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Telnet is a simple remote terminal protocol for remote login. Using Telnet, the user can login to
a remote host with its IP address of hostname from his own workstation. Telnet can send the user’s
keystrokes to a remote host and send the remote host’s output to the user’s screen through a TCP
connection. This is a transparent service. To the user, the keyboard and monitor seem to be
connected to the remote host directly.
Telnet employs the Client-Server mode, the local system is the Telnet client and the remote
host is the Telnet server. ES4710BD can be either the Telnet Server or the Telnet client.
When ES4710BD is used as the Telnet server, the user can use the Telnet client program
included in Windows or the other operating systems to login to ES4710BD, as described earlier in
the In-band management section. As a Telnet server, ES4710BD allows up to 5 telnet client TCP
connections.
As Telnet client, ES4710BD uses telnet command under the Admin Mode to allow the user to
log in to the other remote hosts. ES4710BD can only establish TCP connections to one remote host
at a time. If a connection to another remote host is desired, the current connection must be dropped.
5.2.2.2 Telnet Task Sequence
1. Configure the Telnet Server
2. Telnet to a remote host from the switch.
1. Configuring Telnet Server
Command Explanation
Global Mode
telnet-server enable
no telnet-server enable
Enables the Telnet server function in the
switch: the “no telnet-server enable”
command disables the Telnet function.
telnet-user password {0|7}
no telnet-user
Configures the username and password to
Telnet the switch: the “no telnet-user
” command deletes the
authorized Telnet user.
telnet-server securityip <ip-addr>
no telnet-server securityip
Configures the secure IP address to login
to the switch through Telnet: the “no
telnet-server securityip ”
command deletes the authorized Telnet
secure address.
Admin Mode
monitor
no monitor
Displays debug information for Telnet
client login to the switch; the “no
monitor” command disables the debug