Accton Technology ES4710BD - Manual (Page 206)

205
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
configure a VLAN name and the switch ports assigned to the VLAN. The “no vlan <vlan-id>”
command deletes specified VLANs.
Parameters: <vlan-id> is the VLAN ID to be created/deleted, valid range is 1 to 4094.
Command mode: Global Mode
Default: VLAN1 is set by default.
Usage Guide: VLAN1 is the default VLAN and cannot be configured or deleted by the user. The
allowed VLAN number is 4094. It should be noted that dynamic VLANs learnt by GVRP cannot be
deleted by this command.
Example: Creating VLAN 100 and entering the configuration mode for VLAN 100.
Switch(Config)#vlan 100
Switch(Config-Vlan100)#
9.2.2.2 name
Command: name
no name
Function: Specifies a name for VLAN, a VLAN name is a descriptive string corresponding to the
VLAN. The “no name” command deletes the VLAN name.
Parameters: is the specified VLAN name string.
Command mode: VLAN Mode
Default: The default VLAN name is “vlanXXX”, where XXX is the VID.
Usage Guide: The switch provides a function to specify different names for different VLANs, this
can make VLAN naming easier to remember and manage.
Example: Specifying the name for VLAN100 to be TestVlan.
Switch(Config-Vlan100)#name TestVlan
9.2.2.3 switchport access vlan
Command: switchport access vlan <vlan-id>
no switchport access vlan
Function: Adds the current Access port to the specified VLAN, the “no switchport access vlan”
command deletes the current port from the specified VLAN, and the port will be partitioned to
VLAN1.
Parameters: <vlan-id> is the VID for the VLAN to add current port, valid range is 1 to 4094.
Command mode: Interface Mode
Default: All ports belong to VLAN1 by default.
Usage Guide: Only ports in Access mode can join specified VLANs, and an Access port can only
join one VLAN at a time.
Example: Adding a Access port to VLAN100.
Switch(Config)#interface ethernet 1/8