Accton Technology ES4710BD - Manual (Page 448)

447
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
z Redistribute imported route cost
z Operation type: Add or Remove
Example: For protocol select OSPF, cost as 5, then select Add. Click Apply button to redistribute
imported route cost 5 with OSPF routing protocol to RIP.
18.5.2.2.2 Metricin/out configuration
Click “Metricin/out configuration” to enter the configuration page
z
In: the value of metric in. Equivalent to CLI command 18.3.2.2.5
z Out: the vale of metric out. Equivalent to CLI command 18.3.2.2.6
z Port: specifies port
z Apply: valid settings in this page
z Default: default settings
Example: Configuring metric in/out value, key in the value in In/Out columns, select port.
18.5.2.2.3 RIP imported route
Click “RIP port imported route” to enter the configuration page
z
Port: specifies port
z Receiving RIP version: sets up port receiving RIP version. Includes version1, version2 and
version 1 and 2. It is equivalent CLI command 18.3.2.2.9.
z Sending RIP version: sets up port sending RIP version, including version1, version2 (BC)
andversion2 (MC). Equivalent to CLI command 18.3.2.2.10
z Receive packet: sets up whether the port will receive RIP packet or not, including yes and no.
Equivalent to CLI command 18.3.2.2.7
z Send packet: sets up whether the port will send RIP packets or not. Equivalent to CLI
command 18.3.2.2.8
z Split-horizon status: sets up split-horizon status, including permit and forbid. Equivalent to
CLI command 18.3.2.2.12
z RIP authentication key: Sets up RIP authentication key. Equivalent to CLI command