Ifb attenuation, Latch disable, Prevent reply signalization – Clear-Com HX System Frames User Manual
Page 94: Applies to, 10 gain options, Aux volume off limit, Headset 1 sidetone permanently on, Headset 2 sidetone permanently on, Input gain, Main volume off limit
Note:
If the destination of an ISO is a panel then Eavesdropping must be enabled in Global
Settings (Advanced Settings section) in order to activate the panel microphone if it is not
already activated. If the destination is not a panel but a device such as a four-wire port
Eavesdropping does not need to be enabled for the destination device.
IFB attenuation
When a port talks to the IFB destination, forced listens are automatically dimmed by the
IFB Attenuation setting.
Note:
You make a port into an IFB destination by enabling Global IFB.
Latch disable
This function prevents talks to the port from latching. If a latch-disabled port is assigned to
a talk key, the key can only talk to the port for as long as the operator physically holds
down the key. A latch-disabled port can be included in a fixed group or party line without
automatically latch disabling the entire fixed group or party line.
Prevent reply signalization
Prevents key signalization for the calling panel appearing on the answerback (reply key).
Applies to:
V-Series Panels, I-Series Panels, Concert, Direct connections, AES Mono, Panel Aux,
FOR-22 and Telephone devices.
5.21.10 Gain options
The following Gain options are available:
Aux volume off limit
Sets the minimum limit for the auxiliary audio output so that the volume cannot be turned
completely off.
Note:
Only available on V-Series panels.
Headset 1 sidetone permanently on
Turns the headset 1 sidetone permanently on.
Headset 2 sidetone permanently on
Turns the headset 2 sidetone permanently on.
Input gain
Allows the input gain to be set. Use the input gain adjust slider to set the required gain
from +15 dB to -45dB (or type in the value). The default is 0dB.
Main volume off limit
Sets the minimum limit for the main audio output so that the volume cannot be turned
completely off.
Note:
Only available on V-Series panels.
94
Eclipse EHX Software User Guide