beautypg.com

Assign multiple sources to ifb from ap panel, System access codes, Dtmf passcodes – Clear-Com HX System Frames User Manual

Page 48

background image

Assign multiple sources to IFB from AP panel

If you select this checkbox, an AP panel can assign multiple sources to an IFB destination.
The IFB hears all the talk from the selected sources.

System access codes

You can protect aspects of system functionality with access codes. Use this tab to enter
codes to unlock features.

Figure 3-19 System Access Codes tab

DTMF Passcodes

Use the DTMF Passcodes section to set the global access codes within the Eclipse HX
v7.5 System. Eight DTMF codes are available for accessing the Eclipse HX System from a
remote location (using DTMF Inward Access).

When you assign a value to any of the eight available DTMF codes, that code becomes
recognizable to any MVX-A16 port in the Eclipse HX System.

Note:

For Eclipse HX-PiCo, only ports 17 to 32 can be configured for DTMF access codes.

You can configure a TEL-14 module that is connected to a MVX-A16 port with a setting
that tells the port to recognize any, all, or none of the configured DTMF access codes.

If any MVX-A16 port has been configured to recognize one or more of the DTMF access
codes, then that port allows any caller to access the system who correctly enters a
recognized access code.

Note:

Access codes are formed of numeric characters and must be four digits long. EHX does
not allow a password field containing fewer than four characters, and only accepts
numerals.

When a user manually dials, the DTMF tones go out on the last selected talk to an
interface. An interface is either a TEL-14, CCI-22, FOR-22 or a Direct.

48

Eclipse EHX Software User Guide