2 label, 3 description, 34 removing an e-que card – Clear-Com HX System Frames User Manual
Page 115: 35 configuring an e-que card for antenna, 1 antenna connections, Label, Description, Removing an e-que card, Configuring an e-que card for antenna, Antenna connections
5.33.2
Label
Label for the port used to assign the port to a path. The label has 10 characters, or can be
split into two parts, each of maximum five characters.
5.33.3
Description
An optional description for the port of up to 255 characters long.
5.34
Removing an E-Que card
To remove an E-QUE card:
1)
In Hardware > Cards and Ports, navigate to the slot number of the E-QUE card
you want to delete. Do either of the following:
• Double click the slot.
• Right click the slot and select Set Card Type.
2)
A drop-down menu is displayed, listing the available card types. Select Empty.
3)
A warning dialog is displayed. To confirm the deletion, click Yes
5.35
Configuring an E-Que card for antenna
1)
To configure an E-Que card for Antenna select the card on the hardware list to
display the configuration screen.
Each of the eight ports on the card is given a port number reflecting the total number of
beltpacks that can be supported using the E-QUE card.
5.35.1
Antenna connections
Figure 5-23 E-Que Antenna Configuration
1)
Select the card port to be configured and open Basic Options under Port
Properties > Beltpack Antenna to set up the port parameters.
115
Eclipse EHX Software User Guide