beautypg.com

52 logic maestro, 1 preferences, 53 beltpacks – Clear-Com HX System Frames User Manual

Page 157: Logic maestro, Preferences, Beltpacks

background image

5.52

Logic Maestro

The Logic Maestro link on the Configuration menu opens the Logic Maestro window. Logic
Maestro allows the user to create complex controls using an interactive graphic editor.

Figure 5-56 Initial Logic Maestro Screen

Logic Maestro operations are described in the Logic Maestro manual.

5.52.1

Preferences

The Preferences link on the Configuration menu opens the Preferences dialog allowing the
matrix system setups to be configured. This dialog is also accessible from the System
Layout screen and is described in chapter 3 under Preferences.

5.53

Beltpacks

Selecting Beltpacks from the EHX setup menu displays the beltpack configuration editor
which allows beltpacks to be added and configured. Before a beltpack works, it must be
registered to the system. The Beltpacks screen is only available if an antenna or splitter
card has been configured in the matrix.

To do this:

1)

In Preferences set the correct DECT system ID and Frequency.

2)

Configure the COM port to use for the beltpacks.

3)

Open the Beltpacks screen, and enter a beltpack.

4)

Connect the required beltpack on the COM port.

5)

Press the Register connected Beltpack to this system button.

157

Eclipse EHX Software User Guide