Using client/server – Clear-Com HX System Frames User Manual
Page 261
The client must able to connect to the server to login. If it cannot connect an appropriate
error is displayed. This problem may even be encountered in the case where the client is
on the same machine as the server when the machine is not connected to the network.
If the access to the server is required with the machine in this state, setting the EHX server
as http://127.0.0.1/EclipseServer/ allows this (this is using the network
loopback address).
Figure 11-2 EHX Client Log in
Note:
To determine the EHX Server Machine Name log in to the EHX Server. Click Start and
then Run. Type cmd into the box and click ok. At the command prompt type ipconfig
/all
. Use the listed Host Name as the EHX server name.
Using Client/server
Username
Each user is distinguished by Username and users on different clients should always use
different Usernames when logging in to the EHX Server.
Usernames on the EHX server are set up by logging in to the EHX Server and using the
User Management facility as described in chapter 3 to set up and manage users.
If a user on a client attempts to log in to the EHX Server with a Username that is already in
use a warning is shown. If the new user continues, the existing user session is terminated,
and the user who has now been logged out is informed.
Host name
When logging in to an EHX server running in client/server mode use the Options button to
display the server that the user is logging on to and enter the server name explicitly
instead of using the default local host name.
261
Eclipse EHX Software User Guide