Clear-Com HX System Frames - Manual (Page 120)

5.40.4 Description
An optional description for the port of up to 255 characters long.
Note: The IVC-32 card must be configured before it can be used.
1) To set the IP parameters click on the Card Properties link on the lower right of
the Matrix Hardware display. This displays the settable parameters.
Figure 5-28 IVC-32 IP Parameters
5.40.5 General
Default ports used by the Eclipse HX system are 6001 for IP Panel communications,
42001 for EHX communications and 1300 for the matrix event log. Ports 42001 and 1300
are used by the UDP protocol.
Eclipse HX system administrators are advised to check with network administrators or IT
that these default ports may be used without causing a conflict with any other application
on the network.
Each IVC-32 card requires a static IP address. It is recommended that these addresses
are issued by IT or the Network Administrator to avoid conflicts with any other system on
the network and are not part of the DHCP dynamically assigned range.
5.40.6 IP port
Sets the port number to be used by the IVC-32 card when communicating over IP. This
parameter should not normally be changed from the default value unless all the IP panels
or Concert server are also updated to use the new port number. If this is not done the IP
panels or Concert server cannot communicate with the IVC-32 card.
Eclipse HX system administrators are advised to check with network administrators or IT
that the default port may be used without causing a conflict with any other application on
the network.
If the IP port number is changed ports 42001 and 1300 should not be used as these ports
are already used by EHX. The Eclipse HX system administrator should check with the
network administrator or IT to obtain a port number to use.
5.40.7 IP address assignment
Manually enter the IP address, subnet mask and default gateway for the IVC-32 card.
120 Eclipse EHX Software User Guide