Clear-Com HX System Frames - Manual (Page 125)

Port number
The port number on the LMC-64 card. This does not have a function as the card does not
provide external ports.
Port function
This is always fixed as Meter.
Label
Label for the E1 direct port used to assign the port to a path. The label has 10 characters,
or can be split into two parts, each of maximum five characters.
Description
An optional description for the port of up to 255 characters long.
The LMC-64 card must be configured before it can be used.
1) To set the IP parameters click on the Card Properties link on the lower right of
the Matrix Hardware display. This displays the settable parameters.
Figure 5-33 LMC-64 IP Parameters
General
Default ports used by the Eclipse HX system are 6001 for IP Panel communications,
42001 for EHX communications and 1300 for the matrix event log. Ports 42001 and 1300
are used by the UDP/ protocol. Eclipse HX system administrators are advised to check
with network administrators or IT that these default ports may be used without causing a
conflict with any other application on the network.
Each LMC-64 card requires a static IP address. It is recommended that these addresses
are issued by IT or the Network Administrator to avoid conflicts with any other system on
the network and are not part of the DHCP dynamically assigned range.
IP port
Sets the port number to be used by the LMC-64 card when communicating over IP. This
parameter should not normally be changed from the default value. Eclipse HX system
administrators are advised to check with network administrators or IT that the default port
may be used without causing a conflict with any other application on the network.
125 Eclipse EHX Software User Guide