Clear-Com HX System Frames - Manual (Page 105)

5.25 Configuring the E-Que card
The E-QUE card is designed to allow Eclipse HX matrices to be connected to
CellCom/FreeSpeak wireless antennas/beltpacks or connected together using E1 or T1
protocol.
5.25.1 Adding an E-Que card
To add an E-QUE card:
1) In Hardware > Cards and Ports, navigate to an available slot number (marked
Empty). Do either of the following:
2) Double click the slot.
3) Right click the slot and select Set Card Type.
4) A drop-down menu is displayed, listing the available card types. Select one of the
following E-QUE card options:
• E-QUE (E1 Direct)
• E-QUE (T1 Direct
• E-QUE (E1 Trunk)
• E-QUE (T1 Trunk)
• E-QUE (E1 Direct/Trunk)
• E-QUE (T1 Direct/Trunk)
• E-QUE (Antenna)
• E-QUE (Splitter)
Note: The E-QUE entry selected should be correct for the intended use as the cards are
configured differently by EHX.
105 Eclipse EHX Software User Guide