29 t1 trunk, 1 port function, 2 label – Clear-Com HX System Frames User Manual
Page 110: 3 description, 4 card properties, 5 clock recovery, T1 trunk, Port function, Label, Description
5.29
T1 trunk
An E-QUE card set to T1 Trunk is used to connect Eclipse HX matrices using T1 trunking
protocol. The System Ports display shows two ports numbered 1 and 25.
Figure 5-17 T1 Trunk Ports
Port 1 represents 24 virtual ports 1 - 24 which are allocated automatically for
communications. Port 25 represents a further 24 virtual ports 25 - 48 that are automatically
allocated.
5.29.1
Port function
This is always set to ‘T1 Trunk’.
5.29.2
Label
Label for the port used to assign the port to a path. The label has 10 characters, or can be
split into two parts, each of maximum five characters.
5.29.3
Description
Option port description up to 255 characters long.
5.29.4
Card properties
For an E-QUE card in T1 Direct mode the Clock Recovery mode and Codec should be set
by clicking on the Card Properties link in the lower right of the hardware display. This
displays the Clock Recovery and Codec setup.
Figure 5-18 T1 Trunk Card Properties
5.29.5
Clock recovery
The data clock may be generated by the E-QUE card (Local Generated) or taken from the
T1 line. Normally the card should be set to ‘Line Recovery’ for connection to a third party
device or a T1 network. For other devices the clock source must be determined before
configuration. Select the correct configuration by clicking on the appropriate radio button.
If connecting two Eclipse HX matrices back to back using T1:
• An E1 or T1 crossover cable is required.
• One E-QUE card should be set to Local Generated clock and the other to Line
Recovery clock.
110
Eclipse EHX Software User Guide