6 remote 2-way radio, 7 remote telephone, 1 remote manual dial – Clear-Com HX System Frames User Manual
Page 250: 2 remote speed dial, Remote 2-way radio, Remote telephone, Remote manual dial, Remote speed dial
Note:
The available members area is filtered according to the active matrix filters, but the
attached area always shows all attached members, even if their matrices are filtered out.
10.6
Remote 2-way radio
If a 2-way radio system if connected via a FOR-22, the 2-Way Radio can operate over an
intelligently linked system.
To configure a remote 2-way radio:
1)
Create a control. Attach the relay for the FOR-22, and set the control as a
secondary action on the FOR-22.
2)
Apply and reset the first matrix.
3)
Switch matrices, and open Panels > Remote Interfaces. Locate the remote 2-
way radio
4)
Program the 2-way radio onto the required panel and click Apply Label
Changes.
10.7
Remote telephone
Remote Telephone functionality enables you to configure a TEL-14 telephone module on
one system to be available for use on another system. To make a remote telephone call,
DTMF tone generation is required.
An Eclipse HX user panel (V-Series or I-Series) can make remote calls both manually
(using the dial pad) and through speed dials.
Note:
For more information about setting up and using the TEL-14 module, see the TEL-14 User
Guide. For more information about user panels, see the V-Series User Guide and the I-
Series manual.
10.7.1
Remote manual dial
User panels can manually dial a remote telephone, using the dial pad. The panel registers
as a dialler to the telephone as soon as the panel starts dialling the telephone through the
dial pad.
When the panel comes out of dial mode (ends the call), registration to the telephone port is
released.
Note:
Only one port at a time (local or remote) can dial the telephone.
10.7.2
Remote speed dial
To set up a speed dial to a remote telephone between two linked matrices:
1)
Open the Panels screen and locate the telephone interface in the label palette
2)
Program the telephone interface onto any required panel(s)
3)
In Controls, select the control for the speed dial and program next to the
telephone interface
250
Eclipse EHX Software User Guide