Clear-Com HX System Frames - Manual (Page 268)

Figure 13-3 Input and Output Gain Settings
You can set the default port gain using the individual port settings on the Cards & Ports
screen. The setting is downloaded to the matrix as part of the map and is displayed by the
crosspoint monitor.
5) Right-click the port gain setting to display the gain levels and show this value as
the default setting so the port may be reset to the EHX value at any time without a
new map download and reset.
If the port gain is set to a non-zero level in EHX and then set to zero using the
crosspoint monitor the gain is shown highlighted in light blue to indicate that the
zero value is not the default value in the map.
6) Right click a cell representing a crosspoint to display a list of options. To toggle a
crosspoint from the On state to the Off state click on the State option and then
click on Toggle in the next menu. Select the Kill option from the State menu to
clear a crosspoint completely.
268 Eclipse EHX Software User Guide