Accumulate dtmf codes, One digit codes, Applies to – Clear-Com HX System Frames User Manual
Page 100: 22 general purpose inputs (gpis), 1 adding and removing gpi-6 modules, General purpose inputs (gpis), Adding and removing gpi-6 modules
Accumulate DTMF codes
This field controls whether only one DTMF selector code can be used (disabled) or
whether multiple DTMF selector codes can be used. The default setting is disabled.
When enabled this allows the incoming caller to make multiple routes by dialling multiple
codes.
One digit codes
If this is set enabled DTMF selector codes are limited to a single digit or the hash (#) and
asterisk (*) characters. The default setting is disabled.
Applies to:
Direct, CCI-22, FOR-22 and TEL-14 interfaces.
5.22
General Purpose Inputs (GPIs)
The Eclipse HX matrix has eight General Purpose Inputs (GPI) on the processor card and
these Inputs are automatically added to EHX in the Matrix Hardware screen as module 0.
Further GPIs can be added to the system using GPI-6 modules by incrementing the
number of GPI modules shown below the list.
Figure 5-8 GPI-6 modules are added/removed from the Matrix Hardware
5.22.1
Adding and removing GPI-6 modules
To add / remove GPI-6 modules:
1)
Open Hardware > GPIs.
2)
The counter next to Number of External GPI-6 modules displays the current
number of GPI-6 modules. To display a drop-down list of numbers, click the
counter.
100
Eclipse EHX Software User Guide