2 configuring gpis, 23 general purpose outputs (gpos), Configuring gpis – Clear-Com HX System Frames User Manual
Page 101: General purpose outputs (gpos)
3)
If you select a higher number than the current number, new GPI-6 modules are
added. Six new GPIs are added per module.
If you select a lower number than the current number, GPI-6 modules and their associated
GPIs are removed.
5.22.2
Configuring GPIs
To configure either a matrix or GPI-6 input:
1)
Identify the input number to be used from the GPIs screen.
2)
Click the row to highlight it.
3)
From the Available Controls list, select the required Talk label.
4)
To transfer the label to the Attached Controls list, do either of the following:
5)
Click the => arrow.
6)
Double click the label.
7)
To detach the Talk label from the GPI, select the required label in the Attached
Controls list.
8)
To detach the label, do either of the following:
• Click the <= arrow.
• Double click the label.
Note:
When using an IMF-3 frame the GPI-6 cable should be connected first to
the matrix GPI data connector before connecting any GPI-6 cards.
5.23
General Purpose Outputs (GPOs)
The Eclipse HX Matrix has 8 Matrix General Purpose Outputs (GPOs), which are
automatically added to EHX in Cards and Ports as module 0.
RLY-6 modules are added/removed from the GPOs screen.
Note:
Panel Relays are also managed from this screen, but are added and removed
automatically when panels are managed from the cards and ports screen.
101
Eclipse EHX Software User Guide