Reconfiguring network settings in windows 7 – Clear-Com HX System Frames User Manual
Page 37
Figure 3-4 Internet Protocol Properties Dialog
6)
Select Use the following IP Address, then enter an IP address of
169.254.0.10
. The subnet mask should be 255.255.0.0.
7)
Ensure that all other settings are blank. Click OK, and then OK again.
The IP address of the computer is now set to the same subnet as the Eclipse HX matrix.
Reconfiguring network settings in Windows 7
1)
Navigate to Start > Control Panel > Network and Internet > Network and
Sharing Centre. The following screen appears:
Figure 3-5 Network and Sharing Centre
37
Eclipse EHX Software User Guide
This manual is related to the following products: