7 configuring dtmf access codes, Multiple code setup, Assign dtmf codes – Clear-Com HX System Frames User Manual
Page 155: Configuring dtmf access codes
example, if the asterisk key is supposed to clear all paths, select [00] from the [*] menu. If
the [One Digit Codes] box is checked, the quick keys cannot be assigned control codes.
5.51.7
Configuring DTMF access codes
Multiple code setup
Multiple codes enable an operator to stack multiple routes so that having called one
destination a sequential call can be made to a further destination without ending the first
call.
Assign DTMF codes
Figure 5-54 DTMF Activations
1)
From the telephones Advanced Setting screen select Assign DTMF Codes to
open the DTMF Assignments screen.
2)
Select the desired destination label from the palette of available destinations, at
the bottom of the screen.
3)
Find the desired code in the DTMF Codes column.
4)
The columns to the right of the DTMF Codes column allow assigning as many as
three talk labels and one listen label for each key. Click in the column for the
desired type of label for the desired code: Talk 1, Talk 2, Talk 3, or Listen. The
selected label appears in the desired cell. If this cell has already been assigned a
label, the new label displaces the old one.
5)
Download the new configuration to the matrix with an Apply Label Changes
download.
Note:
Although above describes a single route multiple routes can be attached to a control.
155
Eclipse EHX Software User Guide